Cable pusher BKS 800
Have you ever been faced with the task of pulling cable along meandering courses, through street under crossings or in narrow ducts? If so, you will know how soon the stress limit of the cable being pulled is reached and how soon you will have to fit a connection piece. In order to avoid premature cable cutting and fitting of connection pieces, it is advisable to use a Bagela Cable Pusher in front of a bend, which will reduce cable stress and allow longer cable lengths to be pulled.
Each use of the Cable Pusher BKS 800 will save the cost of fitting one connection piece. No extra time will be squandered for:
- cutting the cable
- moving the cable drum
- excavating a connection pit
- barring of the connection pit
- refilling the connection pit
Function:
The cable passes over two pairs of tapered pulleys, which are driven by electric or hydraulic motor. Two counter pulleys press the cable into the grooves of the two driving pulleys, thus ensuring adequate friction. For effective power transmission the tapered driving pulleys are consisting of a special, highly elastic, tough and wear-resistant rubber material with a high coefficient of friction.
The gap between the tapered pulleys can be varied, so that cable and tubes of 30 to 180 mm in diameter and three single lead 20 kV cables in one strand can be pushed. After the cable has been laid in place, the press-on unit can be removed and the cable taken out and put aside. As the machine is extremely low (340 mm), there will be no unwanted bends in the cable after pushing. Owing to its compact design the cable pusher may be used in any cable trench or pit.
The cable pusher is driven by an electric motor. By means of appropriate power distributors, several cable pushers may be operated in parallel. Upon request, the cable pusher will be supplied with hydraulic motor to be connected to a hydraulic power pack or the hydraulic system of a mini-excavator.
Cable Pusher BKS 800 used for laying 110 kV cable in an industrial site. Where the passage is free, cable pulling may be continued by means of a cable-pulling winch, which draws the cable direct on to the cable holding shelves.
Accessories
BHA 200/10
Hydraukilc power pack with petrol engine
Order No. 010.120.01
Hydraulic hoses with speedadjustment, 5 m
Order No. 003.558.01
Technical Data
| Type | Push power kN | Rate m/min | Drive Engine | Length mm | Width mm | Height mm | Weight kg | Order No. |
|---|---|---|---|---|---|---|---|---|
| BKS 800 E | 8 | 0-10 | 1,5 kW/ 380 V |
1300 | 450 | 650 | 178 | 012.002.00 |
| BKS 800 H | 8 | 0-10 | - | 1300 | 450 | 650 | 150 | 012.002.10 |
| BHA 200/10 Hydr. Power Pack | - | - | Petrol, 4kW | 600 | 400 | 550 | 65 | 010.102.02 |
| Hydraulic hoses | with adjustment | 5 m + 1,25 m | - | - | 10,2 | 003.558.01 | ||
| Hydraulic hoses | without adjustment | 10 m | - | - | 10,8 | 003.558.02 | ||
Type E: Elektric motor with mechanical gear
Type H: Hydraulic motor driven by hydraulic power pack
Painting Traffic red RAL
